R&S®TS8996 RSE Test System

Характеристики - R&S®TS8996 RSE Test System

Fully automatic emission measurements on wireless communication equipment
Key Facts

• Frequency range from 30 MHz to 18 (40) GHz
• Radiated measurements in line with ETSI EN 301 489-n, FCC part 15 and 3GPP TS51.010 standards
• Conducted spurious emission measurements from 100 kHz to 12.75 GHz on antenna connector of the DUT
• The modular design of the filter bank makes technology upgrades and maintenance quick and easy

The R&S®EMC32/R&S®AMS32 Measurement Software contains open source software packages. Copies of the respective licenses are included in the 'R&S®EMC32 and R&S®AMS32 Measurement Software Open Source Acknowledgement'.- Please refer to the Download/Software area of this web site.
Brief Description The R&S®TS8996 RSE test system is designed for EMI and radiated spurious emission tests on wireless devices. The test system is often combined with a semi-anechoic or fully-anechoic chamber. The high-sensitivity filters are contained in modular shielded units, eliminating the need for a shielded control-room. The R&S®TS8996 is applicable during R&D or for EMC type approval. Typical devices under test (DUTs) are mobile phones, cellular base stations, radio sets and other short-range devices. The relevant standards for these DUTs stipulate a wide range of test setups and a wide and high frequency range (up to 40 GHz). All tests according to these standards can be performed with the R&S®TS8996. The test system can be easily adapted to customer-specific requirements.
Features & Benefits

• Software The software (R&S®EMC32), which forms part of the system, enables fully automatic simple testing. R&S®EMC32 is characterized by the following features:
  • Operation under Windows XP
  • Fully automatic, interactive measurements
  • Evaluation of narrowband/broadband interference
  • Automatic compensation of transducers (correction factors) and limit lines
  • Test setup calibration
  • Convenient and flexible result display and documentation
  For more detailed information please refer to the R&S®EMC32 data sheet. The complete software package runs on a PC or PC-compatible industrial controller. The system components are driven via the IEC/IEEE-bus interface.
• Special Features For measurement on wireless devices:
  • Automatic setup and control of the wireless link
  • Control of different 3D EUT manipulators
  • ERP/EIRP measurement
  • Automatic suppression of carrier signal by R&S®T8996 filter unit